shaunbresnahan
August 27, 2013 07:15 pm
I Have a 2.5td N reg XM and I keep getting a wet head every time it rains hard ...I have taken it to my two Xm garages.three times .I have had the sun roof out. and put back but it still leaks water,through the sun visors..I can hear water slashing around in my front door pillars I need to clean out the internal gutter but where do they come out....Does any body know? On my BX I could take out the rear lamp and rod and clean through that..There must be a bit of water draining out because I can see s4 light water marks on the ground by each wheel But how can I clean them effectively.......Shaun
Peter.N.
August 27, 2013 10:29 pm
Water can also get in via the aerial mounting, take it off, clean it and assemble with a little waxoil.
Peter
xmexclusive
August 31, 2013 12:34 am
Outlets are "top hat" shaped plates spot welded on the outside of the top chassis rails.
Remove the front wheel arch liners to see them.
Do not poke a wire up too far as the tubes are set in expanding foam.
As a result the tubes are compressed to odd shapes and easily puntured.
Use a rounded top plastic rod for cleaning.
John
shaunbresnahan
September 01, 2013 01:34 am
Thanks Peter you were dead right about the arial it was very loose..enough to let water in ..Its all sealed up now..It seems so obvious now..Thanks Shaun
shaunbresnahan
September 01, 2013 01:39 am
Thanks John .I am sure I am going to have to do this soon...Now I know how..Thanks Shaun
This is a "lo-fi" version of our main content. To view the full version with more information, formatting and images, please
click here .