robertmnorton
February 04, 2009 09:19 pm
just found this buried in my archives,it clearly shows where to place the hyractive valves replacement diodes.
Peter.N.
February 04, 2009 11:21 pm
Yep, but unfortunatly not all the PCBs are the same. I came across one that didn't conform recently, although the diodes went in roughly the same position the print was laid out differently. If you have another one to check it against, its not to difficult to trace the connections.
lez
February 05, 2009 01:54 am
.,,,,,,,,,,
Jan-hendrik
February 06, 2009 12:40 pm
| QUOTE (robertmnorton @ Feb 4 2009, 20:19 PM) |
| just found this buried in my archives,it clearly shows where to place the hyractive valves replacement diodes. |
Yes, looks familiar to me. My ex XM had the same layout.
Peter.N.
February 06, 2009 02:17 pm
I have only so far come across one that is different, it had three pairs of solder pads and it wasn't immediatly obvious which ones to use, but a little judicious prodding with an ohm meter revealed all.
This is a "lo-fi" version of our main content. To view the full version with more information, formatting and images, please
click here .