Heater Blower Electronic Assembly, schematics needed| Welcome Guest ( Log In | Register ) | Resend Validation Email |
   |
Heater Blower Electronic Assembly, schematics needed| John Malkovich |
Posted: September 30, 2008 08:19 am
|
|
Advanced Member  Group: Members Posts: 110 Member No.: 1214 Joined: February 18, 2008  |
The PCB on blower motor assembly has finally burned out due to condensed water pouring from blocked A/C spigot on every left turn during all summer. I will have to rebuild it but I would need to know the exact electronic parts list. Anyone can help? Thank you in advance.
-------------------- XM 3.0 V6 Exclusive 1997 RP 6591
|
 
|
| Ciaran |
Posted: September 30, 2008 09:05 am
|
 Andre's Mate Group: Members Posts: 1434 Member No.: 222 Joined: August 12, 2005 |
Can't help with the components list sadly John, but if you find yourself stuck you should be able to lift the transistor board off the motor of any PSA vehicle, as long as the wiring arrangement is the same (e.g which connector it has etc)
Ciarán -------------------- '95 XM 2.1TD VSX Hatch: RP 6429. Rare green ;-)
'90 XM 2.0 SEI Hatch: RP 4832 - 'Gandalf the grey' '95 Xantia 1.9TD SX Hatch: RP ????. Black - 'Darth Vader'. Will be MOT'd '95 Xantia 1.9TD SX Hatch: RP ????. Blue - Utterly fooked Location: Outskirts of Belfast in the sunny north of Ireland... |
|
|
| Peter.N. |
Posted: September 30, 2008 11:22 am
|
 Andre's Mate Group: Members Posts: 3414 Member No.: 78 Joined: August 31, 2004 |
There is very little to it, its the transistors that usually fail, even on undamaged units. I have used any TO3 type PNP power transistors rated at 15a or more. I am told that the originals are Darlington pairs, but I have quite successfully used ordinary bipolar transistors.
Peter.N. -------------------- Used to have:
'96 'N' 2.1 td VSX manual estate White RP6695. '01 'Y' 406 GXL Hdi 110 manual estate silver '01 C5 estate 2.0. Hdi 110hp manual Located in Charmouth, Dorset. U.K. Blower transistors MJ 11015 |
|
|
| Ciaran |
Posted: September 30, 2008 11:49 am
|
|
Andre's Mate Group: Members Posts: 1434 Member No.: 222 Joined: August 12, 2005 |
I found these Darlington MJ11015s from RS did the job well too.
Only minor flaw in them is they run the motor at a veeeeeerrry slow speed with the switch set to 0, when the ignition is on, but we're talking like 3 RPM here. Other than that, they work very well throughout all the running speeds, and have been reliable. I put them back in with a thin layer of silicon based heatsink compound, normally used for computer CPUs, and it seems to cool them well. Ciarán This post has been edited by Ciaran on September 30, 2008 12:01 pm -------------------- '95 XM 2.1TD VSX Hatch: RP 6429. Rare green ;-)
'90 XM 2.0 SEI Hatch: RP 4832 - 'Gandalf the grey' '95 Xantia 1.9TD SX Hatch: RP ????. Black - 'Darth Vader'. Will be MOT'd '95 Xantia 1.9TD SX Hatch: RP ????. Blue - Utterly fooked Location: Outskirts of Belfast in the sunny north of Ireland... |
|
|
| John Malkovich |
Posted: September 30, 2008 01:06 pm
|
|
Advanced Member Group: Members Posts: 110 Member No.: 1214 Joined: February 18, 2008 |
Thank you. Well, I suppose Darlington pairs will not be required here since we're talking about high power output transistor. I can't read the original marks on them. Can you please quote?
-------------------- XM 3.0 V6 Exclusive 1997 RP 6591
|
|
|
| xmexclusive |
Posted: September 30, 2008 01:55 pm
|
|
Andre's Mate Group: Members Posts: 2877 Member No.: 144 Joined: April 06, 2005 |
Hi John
Have refreshed a Blower topic that lists the original TI devices. John -------------------- An interest in 2.5TD's.
Location: Hampshire, U.K. |
|
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
 |
|
Skin arobase par alphega @ PCentraide 2005 (original)
V1.3 par Elianora la blanche @ La Caverne de la Rose pourpre
V1.3 par Elianora la blanche @ La Caverne de la Rose pourpre
Powered by Invision Power Board(U) v1.3.1 Final © 2003 IPS, Inc.