Series 1 To Series 2 Interior (saloon)| Welcome Guest ( Log In | Register ) | Resend Validation Email |
   |
Series 1 To Series 2 Interior (saloon)| Bantam |
Posted: June 28, 2008 03:14 pm
|
 Advanced Member  Group: Members Posts: 65 Member No.: 1217 Joined: February 23, 2008  |
Hi all,
Has anyone ever fitted a Series 1 interior to Series 2 car ? Are they the same ? Door cards and center arm rest/pod ? Thanks -------------------- Xm - 1996 2.1TD Series 2 Hatch
|
 
|
| citroenxm |
Posted: June 28, 2008 04:26 pm
|
|
Andre's Mate Group: Members Posts: 2058 Member No.: 257 Joined: October 10, 2005 |
Dont think anyone has done it.. But I reckon its VERY possible...
Centre consoles would NOT be a problem, they are the same.. its a case of was there a difference in the heaters/air con units and / or the metal work behind the dash.. if these are the same or similar there shouldn't be a problem.. its one of the first things that put me off a S2, the "Xantia" dash... its not individual and I think it makes the interior less airey... Paul -------------------- 1993 K Reg 3.0 V6 12 Valve Auto (Green) LPG S1.5 SORNd
1990 H reg 3.0 V6 24 valve Manual. Grey S1 SORNd 1991 H reg 2.1 SED td Manual, Maroon. SORNd 1992 K reg 2.1 SD Manual. Getting ready to sell on 1998 V reg Xantia HDi Exclusive Silver Location: YOU'LL NEVER FIND ME!! |
|
|
| Andmcit |
Posted: June 28, 2008 06:49 pm
|
 Andre's Mate Group: Members Posts: 2086 Member No.: 7 Joined: August 15, 2003 |
I'm sure all the differences are well documented in older listings, xmexclusive has been
here before I'm sure and IIRC Ciarán has done a conversion and did a detailed blog too... I recall the s1 door trims being a different shape where they meet the dash as well as different seat runners seatbelts and electrics making seat swapping difficult too. Andrew This post has been edited by Andmcit on June 28, 2008 06:50 pm |
|
|
| citroenxm |
Posted: June 28, 2008 10:13 pm
|
|
Andre's Mate Group: Members Posts: 2058 Member No.: 257 Joined: October 10, 2005 |
Nothings difficult with the knowledge
     Paul -------------------- 1993 K Reg 3.0 V6 12 Valve Auto (Green) LPG S1.5 SORNd
1990 H reg 3.0 V6 24 valve Manual. Grey S1 SORNd 1991 H reg 2.1 SED td Manual, Maroon. SORNd 1992 K reg 2.1 SD Manual. Getting ready to sell on 1998 V reg Xantia HDi Exclusive Silver Location: YOU'LL NEVER FIND ME!! |
|
|
| xmexclusive |
Posted: June 29, 2008 12:47 am
|
|
Andre's Mate Group: Members Posts: 2877 Member No.: 144 Joined: April 06, 2005 |
Hi Bantam
As has been said, all can and has been done. Some of the results look truly appalling. With a little research and care with the selection of bits some very good results can be achieved. As Andmcit mentioned the dash end shape is mirrored by the front door trim. Change one and not the other and you get a noticable missmatch. With front seats it is best to swap the base frames so there are no wiring or seat belt problems. If you want the resulting seats to look right then avoid buying early Mk1 leather seats to fit Mk2's. The Mk1 centre arm rest steel frame needs a bit of butchering to let the airbag/seat belt sensor fit back down. As well as the arm rest motor frame you also need to recover the centre consol and the arm rest box as they both have extra fittings compared to the fixed arm rest version. Regards XMexc -------------------- An interest in 2.5TD's.
Location: Hampshire, U.K. |
|
|
| Bantam |
Posted: July 07, 2008 11:10 am
|
|
Advanced Member Group: Members Posts: 65 Member No.: 1217 Joined: February 23, 2008 |
Thanks everyone not going to try this....Cheers
-------------------- Xm - 1996 2.1TD Series 2 Hatch
|
|
|
0 User(s) are reading this topic (0 Guests and 0 Anonymous Users)
0 Members:
 |
|
Skin arobase par alphega @ PCentraide 2005 (original)
V1.3 par Elianora la blanche @ La Caverne de la Rose pourpre
V1.3 par Elianora la blanche @ La Caverne de la Rose pourpre
Powered by Invision Power Board(U) v1.3.1 Final © 2003 IPS, Inc.