Bulbs Behind The Heater Panel, Changen bulbs

[SweMike]

Some bulbs behind my heater panel (ACC) has gone out. I have dismanteled my dashboard before but never the ACC-panel. How do I dismantle the acc-panel to change the bulbs? Btw.. Does anyone know where to buy some more sockets for the dashboard?

[citroenxm]

have you the roatry dial controls or the electronic control panel?

If its the roatry dials, pull off the roatry controllers, and behind the left and right one theres two screws, these screws hold the front on..

Remove the front and the bulbs will pull out of the holders for you to replace..

push the front back on, screw screws in, and press the roatry dials back inplace BE CAREFULL THEY ONLY GO IN INE WAY!!!

BUGGER: Just realised, yours is a S2 car, the procedure may well be different. My description is for S1 cars to 1994..


Good luck

C

This post has been edited by citroenxm on March 12, 2008 11:22 am

[robertmnorton]

Hi SweMike, straight forward enough for the digi climate control panel.It is simply retained by a spring clip on each side - though firmly - so prise the panel out using a broad flat strip of metal, chamfered at the end, i have a piece of 20 gauge stainless also used for seperating the upper and lower parts of the dash. The bulbs are retained on the cicuit board and simply twist 45deg and pull to release.

[SweMike]

I have the eldery version with rotary dial controlls. I make differ between ACC and ECC. ECC is for me the digital version.