| Welcome Guest ( Log In | Register ) | Resend Validation Email |
![]() ![]() ![]() |
| dean |
Posted: July 20, 2007 06:50 pm
|
![]() Andre's Mate ![]() ![]() ![]() ![]() ![]() ![]() Group: Members Posts: 1441 Member No.: 852 Joined: May 23, 2007 |
Hi all
It may seem like I've posted a lot of probs on here lately But since I've got my new donor car I'm trying to sort out some of those long running niggles, so here goes. When i blip the throttle, the engine splutters a bit revs then drops to a point where i think it will almost stall, then evens out, it only happens on warm up. I have got new coil, plugs, amplifier module, and leads so does anyone have any ideas, Would a slightly blowy exhaust cause this problem? Cos i have one -------------------- 92 xm 20i prestige auto (modified)R.P 5678
96 Xantia Activa (modified) location-Isle of wight |
| dean |
Posted: July 23, 2007 11:54 am
|
![]() Andre's Mate ![]() ![]() ![]() ![]() ![]() ![]() Group: Members Posts: 1441 Member No.: 852 Joined: May 23, 2007 |
HI all
Sorted it over the weekend, It appears to have been the aux air valve seal on the inlet manifold leaking or the valve itself cos after a good clean and a new seal its fine again now, hopefully! -------------------- 92 xm 20i prestige auto (modified)R.P 5678
96 Xantia Activa (modified) location-Isle of wight |
| aengus-xmv6 |
Posted: August 14, 2007 10:03 pm
|
|
Super Member ![]() ![]() ![]() ![]() Group: Members Posts: 297 Member No.: 622 Joined: February 05, 2007 |
is that the plunger type air-control valve? (magnetti marelli system)
will do it from time to time, and rev by itself too. Strip & clean then reassemble usually sorts it - or just disconnect the hose from the air cleaner to it and spray in carb cleaner with engine running for a short-term relief. regards Dave -------------------- G-reg XM V6SEi saloon, light blue, RP4764
Plus a load of S1 V6 spares in the garage! Previous cits: XM 2.0SEi auto (H) XM 2.0SEi manual (J) BX19 GTi Essex |
| dean |
Posted: August 19, 2007 02:47 pm
|
![]() Andre's Mate ![]() ![]() ![]() ![]() ![]() ![]() Group: Members Posts: 1441 Member No.: 852 Joined: May 23, 2007 |
Hi Dave
Its the Bosch motronic system, The valve seats into the manifold with a thick rubber seal, which was split!, and the valve brings air from a point in the inlet trunking between the filter housing and the manifold. Following your suggestion i took it off again and gave it a good clean, all seems well again now thanks Dean -------------------- 92 xm 20i prestige auto (modified)R.P 5678
96 Xantia Activa (modified) location-Isle of wight |
| Ciaran |
Posted: August 19, 2007 04:17 pm
|
![]() Andre's Mate ![]() ![]() ![]() ![]() ![]() ![]() Group: Members Posts: 1434 Member No.: 222 Joined: August 12, 2005 |
I really must get round to doing this, mine behaves much the same sometimes, can stall occasionly with it as well...
Glad you got it sorted Dean, nice to have a simple fix for once! Ciarán -------------------- '95 XM 2.1TD VSX Hatch: RP 6429. Rare green ;-)
'90 XM 2.0 SEI Hatch: RP 4832 - 'Gandalf the grey' '95 Xantia 1.9TD SX Hatch: RP ????. Black - 'Darth Vader'. Will be MOT'd '95 Xantia 1.9TD SX Hatch: RP ????. Blue - Utterly fooked Location: Outskirts of Belfast in the sunny north of Ireland... |
| dean |
Posted: August 19, 2007 04:29 pm
|
![]() Andre's Mate ![]() ![]() ![]() ![]() ![]() ![]() Group: Members Posts: 1441 Member No.: 852 Joined: May 23, 2007 |
Hi Ciaran
I must admit when i noticed the symptoms, i couldn't help but think the worst, because with an XM it nearly always is -------------------- 92 xm 20i prestige auto (modified)R.P 5678
96 Xantia Activa (modified) location-Isle of wight |
![]() |
![]() ![]() ![]() |