Aircon Woes!, Snapped hose assy

[Michael P]

Hi

I was just in the process of rejuvenating my aircon and put in all new seals onto the hose assys because one blew (see my previous posts). As always, all went fine until the last nut didn't move easily (Condenser, driver side of the vehicle) and while turning it the hose assy bent and was for the bin. While then trying to get ot off the condenser it wrapped up like sello tape!. This is soft and thin aluminium! I hope the condenser didn't get ruined as well in the process. Well, that was the end then of my aircon dreams, I suppose - until, I mean maybe (just maybe) you have a S1 model with aircon to scrap where I could get hold of a replacement hose assy. Mine is an R12 car.

Michael

[citroenxm]

Hi.

Purchase a Series Two with Air con and SWAP ALL engine components over! They DO Fit I have done it on my R12 1992 K reg V6.

Awaiting one hose not to complete, but the evaporator under dash use the same connections, just the rest of the items are different for the gas types.

Condensers are expensive too, but i have 2 series 2 units.

Regards
citroenxm